PonyProg :  PonyProg Phorum PonyProg
PonyProg open discussion 
Go to Topic: Previous•Next
Go to: Forum List•Message List•New Topic•Search•Log In•Print View
Ponyprog with atmega328
Posted by: jman 31 ()
Date: May 17, 2010 04:00PM

Is there any way to program an atmega328 with ponyprog? I am in desperate need of a way to get a hex file to it with a parallel programmer.

Thanks for any suggestions or advice,
Jeremy

Options: Reply•Quote
Re: Ponyprog with atmega328
Posted by: glenns ()
Date: May 26, 2010 11:56PM

Hi Jeremy,
Did you figure out a way to do this? I would also like to program a 328 with ponyprog.
Cheers,
Glenn.

Options: Reply•Quote
Re: Ponyprog with atmega328
Posted by: jman 31 ()
Date: May 27, 2010 03:48PM

No. I wish I could. It doesn't even have to be Ponyprog, but I am familiar with this program so I thought that would be the best way. I wish there was some support on this forum to at least let us know if it is possible. I saw where others had asked about this chip also.

Options: Reply•Quote
Re: Ponyprog with atmega328
Posted by: glenns ()
Date: June 03, 2010 12:14AM

OK, I ended up using AVRdude, not as friendly but worked fine.
Glenn.

Options: Reply•Quote