Hi Cobra,
now I understand you. You have STK500 programmer and you want to program attiny2313 with PonyProg2000.
So this is not possible, because STK500 uses standard serial communication protocol between it and PC and then its main processor have to establish the communication to the programmed chip according to the received commands from serial port.
PonyProg2000 (+ its SI Prog "programmer"
generates raw bus signals (e.g. clock, serial data output, reset ...) to establish the communication to the programmed chip.
Yours sincerely
sonix
cobra Wrote:
-------------------------------------------------------
> da li je moguce with PonyProg Attiny2313 fuse byte
> pisati ako imam hardware STK500
>
> da lit ta kombinacija radi ? ? ?
>
> da li je potreban oscilator 4mhz