PonyProg :
PonyProg Phorum
PonyProg open discussion
Re: MX25L8005
Posted by:
Mike
()
Date: January 15, 2012 05:30PM
Im trying to read MX25L1605...
This is 2MBytes SPI flash.
Seems like PonyProg does not support this type of flash - if select in options device "SPI eeprom" and device type "25160", it reads only 2048 Bytes (instead of 2048 KBytes).
This is 2MBytes SPI flash.
Seems like PonyProg does not support this type of flash - if select in options device "SPI eeprom" and device type "25160", it reads only 2048 Bytes (instead of 2048 KBytes).
Re: MX25L8005
Posted by:
Mike
()
Date: January 15, 2012 06:41PM
I found another SPI project: spiflash.org
Peoples say it works fine.
Now i dont see another way how to flash this MX25L1605.
Its pity that PonyProg doesn't work. This is great project, but probably only one thing miss - just some software support...
Now we should to make a new hardware for SPIFlash programmer.
Peoples say it works fine.
Now i dont see another way how to flash this MX25L1605.
Its pity that PonyProg doesn't work. This is great project, but probably only one thing miss - just some software support...
Now we should to make a new hardware for SPIFlash programmer.
Re: MX25L8005
Posted by:
Mike
()
Date: January 17, 2012 09:19PM
So, spiflash is good project.
Reading and writing MX25L1605 is OK.
I used 74LS245 (see datasheet...) from old ISA multicard, and this simple sch s017.radikal.ru/i441/1111/c0/4ae8fe47b80c.jpg
All components mounted on a back side of DB25(M) connector, length of wires no longer than 3-5cm.
Power supply,
Flash IC Vcc: 3V Li battery CR2032
74LS245 Vcc: USB +5V.
PS: I tried to use this programmer on a few PCs... It works fine on one, and doesn't work at all on another (all received bytes is FF) due to some software/BIOS/settings issues.
Reading and writing MX25L1605 is OK.
I used 74LS245 (see datasheet...) from old ISA multicard, and this simple sch s017.radikal.ru/i441/1111/c0/4ae8fe47b80c.jpg
All components mounted on a back side of DB25(M) connector, length of wires no longer than 3-5cm.
Power supply,
Flash IC Vcc: 3V Li battery CR2032
74LS245 Vcc: USB +5V.
PS: I tried to use this programmer on a few PCs... It works fine on one, and doesn't work at all on another (all received bytes is FF) due to some software/BIOS/settings issues.
Re: MX25L8005
Posted by:
Jan
()
Date: January 27, 2012 09:43PM
Thank you very much Mike. Greetings !
Re: MX25L8005
Posted by:
sanjeev
()
Date: February 07, 2012 04:52AM
hii accidently flashed my bios (MX25L8005) is there anyway to program it and bring back my mobo to life?
Re: MX25L8005
Posted by:
sanjeev
()
Date: February 21, 2012 03:43AM
check this spi flash programmer
http://tehnikservice.net/2011/03/30/spi-flash-programmer/
http://tehnikservice.net/2011/03/30/spi-flash-programmer/