Re: I2CBus Stop condition error (bad timing?) (-20)
Posted by:
Anonymous User
()
Date: January 08, 2008 05:03AM
It works in Windows, though! Hooray!
I had to configure the parallel port, though. "Probe" did not work, but then I clicked "Enable legacy Plug and Play detection" in the Device Manager and it works now.
(It works on another Windows computer, too. So the timing error seems to be Linux-only. I ran the program using sudo, and it was able to "Probe" the parallel port with easyI2C attached, but was not able to read or write.)
Edited 2 time(s). Last edit at 01/09/2008 10:25PM by endolith.
Attachments:
parallel port config.png (51.4 KB)